SHIMPO FGS-100E - Manual (Page 8)

7
4. Operation Panel Functions
1
2
3
4
1
7
11
8
6
10
5
No. Names Function
1
UP
Set Movement Speeds for Manual (MAU), JOGGING (JOg) Modes and during PUSH/
PULL Operation in 1 Cycle (SIg) and Continuous (CON) Modes.
inch/min Mode : Pressed once , the movement speed increases/decreases by 0.01
if pressed continuously , it changes at the rate of 0.1 .
mm/min Mode : Pressed once , the movement speed increases/decreases by 1 ,if
pressed continuously , it changes at the rate of 10 .
2 DOWN
3 MAX
Overrides to the maximum speed value possible of the Stand's motor when pressed.
Once released, the speed returns to the previous set value.
4
MODE Scroll through the Modes (MAU)
5 LCD Displays the condition of Movement Speed, Mode, Alarms. Etc.
6 PULL Starts the Operation of PULL Direction
7
PUSH Starts the Operation of PUSH Direction
8 STOP Stops Test Operation
9 MAX_LED Pressing MAX Key, when the Movement Speed is at Maximum, the Lamp lights.
10
PULL_LED During PULL Operation it flashes
11 PUSH_LED During PUSH Operation it flashes
LCD Normal Display
1) Sub Display Parts:
Presently selected Operation Mode is displayed at the top Sub-Display of LCD.
Limit Position, Over Load condition, or when the Emergency Stop is ON, the Operation Mode and all the Indicators
light-up alternately.
① Limit Position Reached in Operation Mode LMT Flashes
② Over Load Occurrence in Operation Mode OVR Flashes
③ When Emergency Stop is ON in Operation Mode EMg Flashes
2) Main Display Parts:
The set movement speed value is indicated in the main display.
Sub Display (Operation Mode)
Main Display (Movement Speed)