SHIMPO FGS-100E - Manual (Page 9)

8
5. Preparation
5.1. Installation of Force Gauge
Using the Allen wrench spanner provided in the
accessories, remove the installation bolts connecting
the Test Stand and the Force Gauge Mounting
Bracket
Attach the Force Gauge to the Force Gauge Mounting
Bracket.
With Installation Bolts, secure to the bracket.
※ Attach the Force Gauge to the Mounting Bracket.
With the 4 Installation bolts, install the Force Gauge
and Mounting Bracket to the Test Stand
Possible Force Gauges to install on the FGS-100E is the FGV Series Force Gauges
5.2. Cable connection to the Force Gauge.
Insert the attached connecting cable to the back-side connector of FGS-100E Stand and connect the
other side to the corresponding connector of Force Gauge.
If this communication cable is not connected, the automatic stop function of the Stand due to a Force
Gauge sensor over load condition may not be available. In order to protect the Force Gauge, ensure
proper connection.