Techne TC-3000G - Manual (Page 35)

[ ‘.’ to insert step ]
[ , to edit ]
33
To insert a pause after an existing stage,
follow the steps for inserting a stage as
above.
Highlight the 'Number cycles' line then press
"Pause"
The prompt line will flash between 'CHANGE
TO PAUSE?' and 'YES or NO'.
Press "Enter" to insert a pause.
The stage number will then be highlighted
with 'Pause' as the only line.
To insert a ‘pause’ into a program
Step 94.0° C 00m30 max
-------- Stage 2 --------
Number cycles
Step 94.0° C 00m30 max
[ CHANGE TO PAUSE ]
[ Yes or No ]
Step 94.0° C 00m30 max
-------- Stage 2 --------
Number cycles 0
Step 94.0° C 00m30 max
-------- Stage 2 --------
Pause
-------------------------
[ to insert step ]
[ to delete step ]