Techne TC-3000G - Manual (Page 41)

39
Step 94.0° C 00m30 max
fst 65.0° C 00m30 max
lst 55.0° C 1m30
[ edit time ]
When you run the program it will automatically increment or decrement in equal steps from the first time
and/or temperature to the last over the number of cycles in the stage. For example: if the first
temperature is 65°C and the last temperature is 55°C, over 30 cycles the temperature will decrease
0.33°C each cycle. Similarly, in the example shown, the time would increase from 30 seconds to 1 minute
30 seconds in 2 second increments.
[ .For hrs/mins ]
Use the "Alpha/numeric" keys to change the
values of the 'lst' line to the final
temperatures and/or times you require.
Press "Enter" for each field you change.
You will exit 'Edit Mode' when you reach the
end of the line.
At any time during programming the TC-3000G, when you are satisfied with the program, you can finish
and accept what you have done by first pressing the "End" key, then follow the instructions on screen.
If you are not sure, wait for the instructions in the prompt line to scroll back to the first line that you see.
To save the program
Stopping what you are doing
A program can only be run once it has been
saved. Press the "End" key.
The prompt line will flash between 'SAVE?'
and 'YES or NO'.
Press "Enter" for 'Yes' to save the changes
you have made.
If you press "End" for 'No' then all the
changes you have made will be lost.
The program is now ready to run and will be
allocated with a unique "Speed dial" number
which can be used to rapidly locate the
program from the main start-up screen.
Use the "Up Arrow" and "Down Arrow"
keys to scroll through the list of options.
-------- Stage 1 --------
Number cycles 10
Step 94.0° C 00m30 max
[ SAVE? ]
GEORGE (10)
Run Program
View Program
[ , to select ]
[ Yes or No ]