Thermo Fisher Scientific CyberScan pH 300/310 - Manual (Page 28)

25
7.2 P 1.0: Memory Clear (CLr)
Use this parameter to clear all memory values when you need
to store a new series of values. This lets you avoid confusing
the old values with the new ones.
NO is the default setting.
NOTE: Selecting YES will wipe out all memory.
From measurement mode:
1. Press the SETUP key to enter Set Up mode.
2. Press the MI/▲ or MR/▼ keys to scroll through
subgroups until you view the parameter P1.0.
3. Press the ENTER key to enter parameter P1.0.
4. Press the MI/▲ or MR/▼ keys to toggle between NO and
YES.
z NO retains current memory
z YES clears all memory.
See Figure 23.
5. Press the ENTER key to confirm selection and return to
the subgroup menu. Press CAL/MEAS key to return to
measurement mode.
Figure 23 - P1.0: Memory Clear