Setup functions, 1 p1.0 cal (calibration), 2 p2.0 ele (electrode information) – Thermo Fisher Scientific Eutech CON 700 User Manual
Page 13: 3 p3.0 conf (configuration), 4 p3.1 rdy (ready / stability indicator)
9
2) To recall data from memory, press
. The location of the most
recent stored data is displayed first. Press
or
to select the
location of the desired data, then press
to accept.
3) Press
to return to the stored data location. Press
to return
to measurement mode. To erase stored data, see Section 6.14.
6. SETUP
FUNCTIONS
Use the set up mode to customize your instrument operation. During
measurement, press and hold
for 5 seconds to enter SETUP
mode.
Press
or
to change programs or change options.
Press
to select the program or confirm selection.
Press
to go back one level or return to measurement mode.
6.1 P1.0 CAL (Calibration)
Press
to view stored calibration points in each range.
6.2 P2.0 ELE (Electrode Information)
Press
to view cell efficiency in each range.
6.3 P3.0 ConF (Configuration)
Press
to access set-up programs 3.1 thru 3.9.
6.4 P3.1 rdY (Ready / Stability Indicator)
Press
.