Audient ASP8024 Large Format Recording Console - Manual (Page 34)

Operation Manual
34
Master Section
© 8.21
SUB GROUP
OUTPUTS
In addition to routing signal
to the group outputs for
recording on a multi-track
recorder, the first eight
groups are also fed to 8 sub
group outputs. Each sub
group has a PAN control,
SOLO and CUT switches
and a fader controlling the
group output level. The sub
groups have insert points
located on the rear panel of
the console allowing
external processing to be
patched in when called for.
The MIX switch assigns
the sub group to the stereo
mix bus and allows the sub
groups to be used in mix
down. The subgroup
INSERT RETURNS can be
used as extra inputs to the
mix.
1 The PAN knob pans the
subgroup signal across
the stereo bus.
2 MIX allows the sub
group to be assigned to
the stereo mix bus and
hence the main console
output.
3 SOLO allows the
subgroup signal to be
auditioned depending
upon the selected pan
mode.
4 CUT mutes the
subgroup output.
1
4 3
2
SUB GROUP FADER
The 8 subgroup faders are
located in the centre of the
console, close to the
operator, and control the
subgroup output levels.
These outputs are directly
available at the rear of the
console or they may be
used to feed the stereo mix
bus simply by pressing the
mix buttons. 1 The SUB GROUP
FADER sets the level of
the subgroup output
signal.
2 This is the +10db mark.
The fader is fully open at
this point and
introducing 10dB of
gain into the signal path.
3 This is the 0dB mark
which is the normal
operation position for
the fader.
4 With the fader here the
signal path is closed and
no signal will pass.
1
3
4
2