Audient ASP8024 Large Format Recording Console - Manual (Page 36)

Operation Manual
36
Master Section
© 8.21
AUXILIARY
MASTERS
The auxiliary masters
control the overall level of
the auxiliary outputs. A
balance or mix can thus be
created by using the
controls on the channel
strips and the overall level
adjusted by using the
auxiliary master control.
The auxiliary outputs can be
solo’d so that a balance can
be created by listening to
the output.
A typical mixing situation
may require that the LF and
SF paths feed the same
effect device.
Although an auxiliary send
can be assigned to either of
the two paths they naturally
cannot access both paths at
the same time. By linking
auxiliaries this problem is
overcome and if the
auxiliary 3 signals need to
be combined with those on
Auxiliary 1 this can be
achieved by simply using
the link facility. The
following combinations are
possible:
AUXs 3 and 5 can be linked
to AUX 1.
AUX s 4 and 6 can be linked
to AUX 2.
AUXs 9 and 11 can be linked
to AUX 7.
AUXs 10 and 11can be
linked to AUX 8.
1 AUXILIARY MASTER
LEVEL controls the
overall auxiliary output.
2 SOLO button used to
audition the auxiliary
output. This is always
AFL.
3 The LINK button is used
when it is required to
combine signals from
different auxiliaries into
a common signal. The
leftmost auxiliary
becomes the overall
master, thus if auxiliary
3 is linked to auxiliary 1
then the output of
auxiliary 1 should be
used as the master
output.
1
3
2