Audient ASP8024 Large Format Recording Console - Manual (Page 53)

Operation Manual
53
Power Supply
© 8.21
THE POWER
SUPPLY
The ASP8120 power
supply is a 3U Rack
Mounting, unit. There are
no controls other than the
ON/OFF switch, a reset
switch for the +/- 18v rails
and the voltage selector
located on the rear panel.
3 LEDs are used to indicate
the existence of the +18V,
-18V and +48V power rails.
There are also PSU status
indicators located on the
master meter section of the
console.
Two very low noise slow
running fans cool the unit
so that it can normally be
located in the same room
as the console.
A 4 metre long power
supply cable is supplied
connecting the console to
the power supply.
It is important that the
power supply ventilation
slots and fans are not
obstructed. There is no
need to allow space
above and below the
unit if it is mounted in a
rack and it may also be
placed directly on a floor
if required.
Before using please
check that the voltage
selector on the back
panel of the PSU is set
correctly for the local
mains supply.
IMPORTANT!
ON
-18V +18V 48V
RESET FUSE
T 500mA