Dwyer TSCC - Manual

Series TSCC Digital Dispensing Temperature Control
Specifications - Installation and Operating Instructions
Bulletin T-TSCC
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46360, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
SPECIFICATIONS
Probe Range:
PTC: -58 to 302°F (-50 to 150°C);
NTC: -58 to 230°F (-50 to 110°C).
Input: 2 free voltage contact input, 1 PTC thermistor 1000Ω @ 25°C
or 1 NTC thermistor 10K Ω @ 25°C.
Output:
1 each relay SPDT 16 A @ 240 VAC resistive, 5 A inductive;
2 each relay SPST 5 A @ 240 VAC resistive.
Control Type: ON/OFF.
Power Requirements: 115 VAC ±10%; 230 VAC ±10% (depending on
model).
Power Consumption: 4 VA.
Accuracy: ±1% FS.
Display: 3-digit and sign, 1/2˝ red LED digits.
Resolution: 1°.
Memory Backup: Nonvolatile memory.
Temperature Limits:
Operating: 32 to 158°F (0 to 70°C);
Storage: -4 to 176°F (-20 to 80°C).
Weight: 8.8 oz (250 g).
Front Panel Rating: IP64.
Agency Approvals: CE, cUL, UL.
The Series TSCC Digital Dispensing Temperature Control is used to
monitor and control product temperature and dispensing rate in the
production of melted cheese, chili, or other heated food products. One
selectable PTC or NTC thermistor is used to monitor the product
temperature while a SPDT relay is used to control the temperature. Two
SPST relays are used for controlling two dispensing rates for either
different size containers or different products. A three digit, easy-to-read
display is included on the controller. The buttons on the face of the
controller enable the user to program the desired control parameters.
Parameters can be copied from one device to another using our TS2-K
configuration key. Security protection is offered using a password code.
WIRING DIAGRAM
3
[76.20]
2-21/32
[67.39]
UNIT
1-7/64
[28.19]
1-11/32
[34.04]
Unit must be mounted away from vibration, impacts,
water and corrosive gases.
Cut hole in panel 2.80 x 1.14 in (71 X 29 mm).
Apply silicone or use the included rubber gasket around the perimeter of
the hole to prevent leakage.
Insert unit into the hole of panel.
NOTICE
POWER SUPPLY VOLTAGE
Take note of the power supply voltage marked on the
controller. Do not exceed the specified power supply voltage.
NOTICE