AT&T E5913B - Manual (Page 25)

22
Telephone operation
Handset settings
Dial type
Using this function, you can choose
TONE or PULSE
(rotary) dialing. The factory default setting is TONE.
Change this to PULSE only if you do not have
touch-tone dialing service.
1. Press
MENU/
SELECT
in idle mode to enter the
feature menu.
2. Use the up or down NavKey or to scroll
to the DIAL TYPE menu, press
MENU
/SELECT to
enter the menu when it is highlighted with a >
symbol.
3. Press the up or down NavKey or to select
TONE or PULSE.
4. Press
MENU
/SELECT to save your preference.
NOTE: If you have more than one handset registered, dial
type change made on any one handset will apply to all.
Temporary ring silencing
Press
OFF/
CLEAR
or MUTE/
DELETE
while the tel-
ephone is ringing to silence the ringer temporarily.
This will silence the ringer without disconnecting
the call. The next incoming call will ring normally
at the pre-set volume.
NOTE: If there is more than one handset in use, all hand-
sets ring with an incoming call except those with the vol-
ume turned off. Press
OFF/
CLEAR
or MUTE/
DELETE
on
one handset will only silence the ringer of that particular
handset but the other handset(s) will continue to ring.
DIAL TYPE
TONE
>
DIRECTORY
CALL LOG
>
DIAL TYPE
DIRECTORY