Changing feature options – AT&T E5913B User Manual

Page 39

Advertising
background image

36

Answering system operation

1.

SETUP

3.

SETUP

- OR -

Press until desired

feature is heard (see

list at right).

Press until desired

selection is heard.

Press to set selec-

tion and move to next

menu option.

Press to set selection

and exit menu.

2.

SKIP

or

REPEAT

PLAY

/STOP

Changing feature options

You can change how the answering system operates.
Press

SETUP repeatedly to hear each feature. When you

hear the feature you want to modify press

SKIP or

REPEAT to change the setting. Press SETUP to confirm

your selection and move to the next menu option or press

PLAY/

STOP to confirm your selection and exit the

menu.
Feature options

(Default settings underlined).

System announces:

Feature description:



"Number of rings,"
current

setting, then "To change
the setting press

SKIP

or

REPEAT; to continue

setup, press

SETUP."

Options: 2/4/6/toll saver

“Base ringer,” current

setting, then “To change
the setting press

SKIP

or

REPEAT; to continue

setup, press

SETUP.”

Options: high/

low/off

"Remote access code,"
current setting, then "To
change the setting press

SKIP or REPEAT; to con-

tinue setup, press

SETUP."

Options: (select two-digit
code)

19

"Message alert tone,"

current setting, then "To
change the setting press

SKIP or REPEAT; to con-

tinue setup, press

SETUP."

Options: on/off

Choose number of rings before the

system answers a call. When toll

saver is active, the system answers

after two rings if you have new

messages, and after four rings if

you have no new messages. When

retrieving messages from a long-

distance call, you may disconnect

your call after three rings so that

long distance charges will not be

charged.

Choose base ringer volume to

high or low level, or turn the base

ringer off.

Select a two-digit number (10-99)

for remote access from another

telephone (page 41).

NOTE: Press and hold SKIP

or

REPEAT to increase or decrease

the remote access code number by

increments of 10.

When on, the telephone beeps

every 10 seconds when there are

new messages.

NOTE:

The message alert tone will beep only if all the conditions below are met:

Answering system is on.
Message alert tone setting is on.
There are new messages. Pressing any telephone base key (except

HANDSET LOCATOR) will tem-

porarily silence the message alert tone. If you press and hold

DELETE in idle mode, you will delete

all old messages and the message alert tone will be temporarily silenced. The message alert tone will
be re-activated with the next incoming message.

Advertising
This manual is related to the following products: