FUTEK IPM52x (D520) Digital Display User Manual

Page 12

Advertising
background image

11

•

When entering numeric data, it decrements the numeric value of

the flashing digit by one with each push.

4.

EXIT KEY

•

If at a Main branch prompt (CODE, CHAN, OUTPUT, DISPLY

or SPEC), it exits to you back to RUN mode.

•

If in a programming branch, it returns you to Main branch

prompt.

NOTE: It does note store data to memory on its return.

ENTER key should be pushed first to store selected entry,

then

EXIT key.

5.

ENTER KEY ( on flow chart indicates to use this key)

•

Enters selected Main program branch.

>

Moves you down in the program branch menu.

>

Menu steps can be skipped by repeatedly pushing

ENTER

key till desired menu step is reached.

•

Enters selected choices, numeric data or decimal point, it stores

the value and advances to next step in the program menu.

SECTION 3.3: RUN MODE KEY FUNCTIONS

A.

Entering SETUP

Push and hold

SETUP key for 4 seconds. Meter will first

display “SET CH” then display “CODE” or flash “SETUP then

display “CHAN”.

•

“CODE” is flashed with 00 if a lockout code has been

under the Main program branch heading SPEC, CODE

menu.

>

The preset lockout must be entered at this time. If

wrong code is entered or if no code is entered within

20 seconds, meter will return to RUN mode.

>

Upon correct lockout code entry, meter enters the

SETUP mode.

>

The unmarked yellow LED just above the Down/F4

key will light, indicating you are in the SETUP mode.

•

If no lockout code, “SETUP” flashed then “CHAN”

displayed, indicating you have entered the SETUP mode.

Advertising