FUTEK IPM52x (D520) Digital Display User Manual

Page 17

Advertising
background image

16

2.

If no key is pushed within 2 minutes while in any other program branch,

meter will automatically exit back to run mode.

SECTION 3.5: ENTER SETUP

•

Press and hold

SETUP key for 4 seconds. Meter will display

“SEL CH” at first then will enter into the Setup mode. The meter

will display “CODE” or “CHAN”.

•

“CODE” is flashed with 00 if a lockout code has

been set under the Main program branch heading

SPEC, CODE menu.

•

The preset code (1-50) must be entered at this

time. If wrong code is entered or if NO code is

entered within 20 seconds, meter will return to

RUN mode.

•

Upon correct lockout code entry, meter enters the

SETUP mode. The status LED between Valley

and NET will light indicating the meter is in the

Programming/Setup mode.

•

The unmarked yellow LED just above the

Down/F3 key will light, indicating you are in the

SETUP mode.

•

If NO lockout code, “SETUP” flashed, then

“CHAN” displayed, indicating you have entered

the SETUP mode. If NO key is pressed within 20

seconds, meter will return to RUN mode.

SECTION 3.6: MAIN PROGRAMMING BRANCHES

Advertising