Innotech iSEA - Manual (Page 22)

Innotech Service & Event Analyser Installation Instructions
Page 22 © Mass Electronics Pty Ltd 2011 Edition 3.1 dated 26.03.2014
3-1.1.2 iComm Points
iSEA utilises a specific TCP Port in order to communicate with iComm. By default, iSEA utilises TCP
Port 21001. In order to specify a different TCP Port, type a new port number into the configuration
window. These settings are important as it is used in the setup of Monitored points and Virtual
Meters in iSEA and iComm.
Setting Function
TCP/IP Port Sets the port number for iSEA connection to iComm.
Enable iComm Point Reporting Enables iSEA to send selected point values to iComm.
Tenant Target Monitoring Points iSEA will report tenant target values for the local Chronicle server
on the target monitoring device.
Virtual Points iSEA will report virtual point values on the virtual point device.
Application Specific
Enables application specific devices to report to iComm.
ie iSEA's Internal Points.
iSEA:
• ChronicleRunning~Output
• SQL_Express~Output
Chronicle Server:
• DbConnected~Output
• iCommConnected~Output
• AllocatedDB~Output
• ReportingUsage~Output
• DongleConnected~Output
• DatabaseLogging~Output
Table 3-2: iComm Points Settings
Figure 3-4: iComm Points Configuration Settings