Innotech iSEA - Manual (Page 23)

Page 23
Innotech Service & Event Analyser Installation Instructions
© Mass Electronics Pty Ltd 2011 Chapter 3 – Configuring iSEA
3-1.1.3 Process Monitoring
These settings enable or disable monitoring of monitored processes and sets the delay in seconds for
process checking and restarting.
Setting Function
Enable Monitoring
Click to enable or disable monitoring of selected Innotech processes
and services.
iComm Comms Check
Time delay before iSEA reports a communications failure with
iComm, after at least two failed attempts.
Terminate Unresponsive App
Time delay before iSEA terminates an unresponsive application. Only
applications with user interfaces (iComm) can be terminated and
restarted using this feature.
Minimum Restart Delay
Time delay before iSEA restarts an application that is detected as not
running.
Table 3-3: Process Monitoring Settings
Figure 3-5: Process Monitoring Configuration Window
Disabling monitored processes will impact data integrity and should only be used for troubleshooting or
maintenance.
IMPORTANT