Sterlco SDD Series - Manual (Page 27)

882.01749.00 27 of 93
initially displayed is the weight which would result in a motor speed of 25%. The valid range of values would
then be ¼ to 2.5 times this initial value.
“DD” Pellet Discs
Disc Calibration Number No. of Pockets Disc Thickness
DD 30-030672 1.75 72 3 mm
DD 30-051040 5.00 40
5mm DD 30-051725 8.00 25
DD 30-051818 15.00 18
“DT” Pellet & Regrind Discs
“DP” Powder Discs
Additive Sample weighing.
Weighing samples of additive provides for more precise control of feed rate. Up to 5 samples can be
weighed. All weights entered are averaged to arrive at a value to be used during operation. The weighing
process may be skipped altogether, in which case the calibration weight is used for calculations of feed rate.
Weight Calibration.
The final step of recipe setup is weight calibration. This procedure is common to all types of presses
supported. After entering the calibration weight, pressing the “Next” button displays the following screen:
Disc
Thickness
Disc
Calibration
Number
No. of
Pockets
10 mm
DT 30-101820 32.00 20
DT 30-102025
(“Sure-shot” - 20
oval holes) 38.00
20 Oval
20mm
DT 30-203012 100.00 12
DT 30-204010 175.00 10
Disc
Calibration
Number
Disc
Thickness
DP 30-050940
17.00
5mm
DP 30-250940 8.00 2.5mm