Sterlco SDD Series User Manual
Page 48
882.01749.00
48
of
93
Displays the current motor speed when running, and the calculated speed when stopped.
Screw Recovery Times Screen (Injection only)
Displays the 5 most recent screw recovery times (latest on top), as well as the simple average and
weighted average.
Manual Run / Jog Screen
This screen is only available when the A250 control is stopped. This screen provides the means to
purge / clear additive, prime additive, etc..
The speed at which the motor will run, jog, or purge. Adjust using the Accel and
Decel buttons.
Pressing and holding either of these buttons will adjust the motor run speed by
approximately 1% of max speed every ½ second. The minimum speed is 5%, while the maximum speed is
100%. The default speed is 50%.