American Power Conversion PDU - Manual (Page 22)

14 150kW InfraStruXure System—Installation and Start-Up
Connect the Power Source to the PDU
Access the PDU Main Input breaker
Open the back doors of the PDU by unlocking the top, smaller door, using the provided key and then
loosening the two screws holding the bottom half of the door in place.
Attach conduit to the PDU for the input conductors
1. Remove the rectangular gland plate by loosening the captive screws, using a Phillips or standard
screwdriver:
– In the bottom of the PDU for wiring under a raised floor: remove the plate in the floor of the
PDU.