Brother SB7050E - Manual (Page 18)

16
GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Basic Steps for Embroidering
This section describes the preparations for embroidering.
The basic steps for embroidering are as follows.
p
p
p
p
p
p
p
1 Embroidery unit attachment
Attach the embroidery unit.
For details, refer to "Attaching the embroidery unit" (page 19).
2 Needle preparation
Use a needle matched to the fabric.
For details, refer to "Replacing the needle" (page 28).
3 Bobbin thread setup
For the bobbin thread, wind embroidery bobbin thread and set it in
place.
For details, refer to "Winding/Installing the Bobbin" (page 29).
4 Fabric preparation
Attach a stabilizer material to the fabric, and hoop it in an embroidery
frame.
For details, refer to "Preparing the Fabric" (page 43).
5
Embroidery frame
attachment
Attach the embroidery frame to the embroidery unit.
For details, refer to "Attaching the Embroidery Frame" (page 47).
6 Pattern selection
Select an embroidery pattern.
For details, refer to "Selecting Embroidery Patterns" (page 50).
7 Upper thread setup
Set up the upper thread according to the selected pattern.
For details on setting up the thread, refer to "Upper Threading" (page 37).
8 Checking the layout
Check and adjust the size and position of the embroidery pattern.
For details, refer to "Adjusting the layout and the size" (page 62).