Brother SB7050E - Manual (Page 88)

86
APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error messages
When erroneous operations are performed messages and advice on operation will be displayed on the
LCD. Follow what is displayed. If you press
or do the operation correctly while the error
message is displayed, the message disappears.
No Error Message Probable Cause
1 There is a possibility that the data for the selected pattern is corrupted.
2
The start/stop button was pressed at a screen other than the embroidery
screen.
3
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press
(Start/stop button)
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
4
The machine is deleting a previously saved pattern while in embroidery
edit mode.
5
You attempted to select a pattern after the USB media containing the
pattern has been disconnected, then reconnected.
6
on the LCD was pressed when no card was inserted.
7
You retrieved a pattern while no USB media is connected.
You tried to use imcompatible USB media.
8
The start/stop button or thread cutter button was pressed while the
embroidery foot was raised.