Brother SB7050E - Manual (Page 83)

Attaching the Embroidery Foot 81
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e
While pressing in the lever with your finger, fit
the embroidery foot bar over the needle clamp
screw to attach the embroidery foot to the
presser foot bar.
a Presser foot bar
b Needle clamp screw
c Embroidery foot bar
f
Secure the embroidery foot with the presser
foot holder screw.
Set the embroidery foot perpendicular.
a Presser foot holder screw
g
Firmly tighten the presser foot holder screw.
Turn the screwdriver toward the front.
a Screwdriver
CAUTION
a
c
b
a
a
● Do not hit the needle with your finger or
the embroidery foot when attaching it.
The needle may break or cause injury.
● Be sure to tighten the screw with the
included screwdriver. If the screw is
loose, the needle may hit the embroidery
foot and break or bend.
● Before embroidering, always turn the
handwheel toward you (counterclockwise)
slowly to make sure that the needle does
not hit the embroidery foot. The needle
may break or bend.