Brother SB7050E - Manual (Page 72)

70
EMBROIDERY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Using the Memory Function
Embroidery data precautions
Observe the following precautions when using embroidery data other than that created and saved in this machine.
CAUTION
■ Types of Embroidery Data That Can Be Used
• Only .pes and .dst embroidery data files can be used with this machine. Using data other than that saved
using one of our embroidery software programs or sewing machines may cause the embroidery machine
to malfunction.
■ Types of USB Media That Can Be Used
Embroidery data can be retrieved from a USB flash drive (USB flash memory) of any size.
Note
z Only a USB flash drive (USB flash memory) can be connected to the USB port on this machine.
z Some USB media may not be compatible with this machine. Visit our website for more details.
z When using USB media equipped with an access indicator, the access indicator will begin flashing
after the media is inserted into your computer or machine, and may take about 5 to 6 seconds before
the media is recognized. (The length of time differs depending on the USB media.)
z For additional information, refer to the instruction manual included with the USB media that you have
purchased.
Memo
z Letters and numerals can be used in folder names and file names. In addition, if the folder or file name
contains no more than eight characters, the entire name will appear on the screen. If the name is more
than eight characters long, only the first six characters followed by “~” and a number appear as the
name.
This applies to folders and .dst embroidery data files only.
■ Precautions on Using the Computer To Create and Save Data
• If a folder or file name for embroidery data cannot be identified, for example, because the name contains
special characters, the folder or file will not be displayed. If this occurs, change its name. We recommend
using the 26 letters of the alphabet (uppercase and lowercase), the numbers 0 through 9, “-”, and “_”.
• .pes files saved with the number of stitches, the number of colors and the number of combined patterns
exceeding the specified limits cannot be displayed. Use one of our embroidery software programs to edit
the embroidery pattern so that it meets the required specifications.
• Even if the embroidery unit is not attached, the machine will recognize embroidery data.
● When using embroidery data other than our original patterns, the thread or needle may break
when sewing with a stitch density that is too fine or when sewing three or more overlapping
stitches. In that case, use one of our embroidery software programs to edit the embroidery
data.