Audiovox FPE-1908DV - Manual (Page 2)

E - 2
PLACEMENT INFORMATION
• Do not use this unit in places that are extremely
hot, cold, dusty, or humid.
• Do not restrict the airflow of this unit by placing
it somewhere with poor airflow, by covering
it with a cloth, or by placing it on bedding or
carpeting.
SAFETy INFORMATION
• When connecting or disconnecting the AC
power cord, grip the plug and not the cord itself.
Pulling the cord may damage it and create a
hazard.
• When you are not going to use the unit for a long
period of time, disconnect the AC power cord.
CONDENSATION INFORMATION
• When left in a heated room where it is warm
and damp, water droplets or condensation may
form inside the unit. When there is condensation
inside the unit, the unit may not function
normally. Let the unit stand for 1-2 hours before
turning the power on or gradually heat the room
and allow the unit to dry before use.
RATING PLATE LOCATION
The rating plate is located on the rear of the unit.
FCC INFORMATION
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an AC power outlet
on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION:
• DANGER OF EXPLOSION IF BATTERY
IS INCORRECTLY REPLACED. REPLACE
ONLY WITH THE SAME OR EQUIVALENT
TYPE.
• TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT
OF WALL OUTLET, THEN FULLY INSERT.
• USE OF CONTROLS OR ADjUSTMENTS
OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED MAY
RESULT IN HAzARDOUS RADIATION
EXPOSURE.
CAUTION
INVISIBLE LASER RADIATION WHEN OPEN.
AVOID EXPOSURE TO BEAM.
This product contains
a low power laser
device.
The symbol for Class II
(Double lnsulation)
The lightning flash with arrowhead
symbol, within an equilateral triangle,
is intended to alert the user to the
presence of uninsulated “dangerous
voltage” within the product’s enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended to alert
the user to the presence of important
operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
SAFETy PRECAUTIONS
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN OR
MOISTURE. DO NOT PLACE OBJECTS FILLED
WITH LIQUIDS ON OR NEAR THIS UNIT.
WARNING: Changes or modifications to
this unit not expressly approved by the party
responsible for compliance could void the user
authority to operate the equipment.
English P1-32.indd 2 6/11/2008 12:22:11 PM