Audiovox FPE-1908DV - Manual (Page 5)

E - 5
QUICK INSTALLATION
When you turn on your television set for the
first time, be sure to place it on a solid stable
surface. To avoid danger, do not expose the TV
to water, or a heat source (e.g. lamp, candle,
radiator). Do not obstruct the ventilation grid
at the rear and be sure to leave sufficient gaps
around the unit as shown.
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter SETUP mode. You can easily follow the
prompt message on the screen to complete basic TV settings.
1. Press the / button to select Yes. Press
the ENTER button to proceed with the
initial setup.
2. Use the / button to select Antenna,
then press the / button to select Air
or CATV.
3. Use the / button to select Auto Scan, then press the button to enter auto scan menu.
Use the / button to select Start to Scan, then press the button to begin scanning. (If
you selected CATV on Step 2, you need to select Cable System before Start to Scan). The
system will automatically start to scan and preset all available TV channels.
4. After scanning has finished, the system will return to the first TV channel scanned.
Make sure the RF aerial has
been connected properly to the
TV ANTENNA input jack on the rear
of the unit.
English P1-32.indd 5 6/11/2008 12:22:13 PM