Canon Color imageCLASS MF9220Cdn - Manual (Page 36)

34
1 Settings Necessary to Use the Machines Functions
The “Setup Guide” only supports IPv4.
By default, the IP address is automatically assigned to the
machine by the DHCP server.
1
Make sure the following screen is displayed on
the display. Use [▼], [▲] or (Scroll Wheel) to
select <Set or Check Now> or <Set or Check
Later>.
A: When you use the machine through the network, select
<Set or Check Now> then press [ OK ].
B: When you do not use the machine through the network,
Select <Set or Check Later>, then press [ OK ]. (Go to
“Finish ‘Setup Guide’,” on p. 36.)
The setting for IPv6 is not supported with the “Setup Guide.”
When you want to use the machine on the IPv6
environment, select <Set or Check Later> and set it up after
finishing the “Setup Guide.” See “Network Settings,” in the
e-Manual.
–
–
2
Make sure the following screen is displayed on
the display, then press [ OK ] to proceed to the
“Setup Guide.”
If the LAN cable is not connected to the machine, a screen
instructing you to connect the LAN cable will appear
before this screen.
If the machine dose not get the IP address 3 minutes after
you connect the LAN cable, check the IP address settings
and the network cable.
3
Make sure the following screen is displayed on
the display, then press [ OK ] to proceed to the
“Setup Guide.”
–
–