Canon imagePROGRAF iPF605 - Manual (Page 160)

Handling sheets
Loading heavyweight paper in the Front Paper Feed Slot
Important
• Before loading heavyweight paper, change the media type setting to POP Board. After POP Board is
selected as the type of paper, you can select Front Paper Feed Slot.
• Always load a POP Board in the Front Paper Feed Slot. Loading it another way may damage the
printer or cause malfunction.
Note
• You can load only one sheet of paper at a time.
• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
• If the paper is warped, straighten it before loading it.
• Load the paper straight. Loading paper askew will cause an error.
• After loading the paper, you cannot move it laterally to reposition it. Be sure to load the paper straight.
1. If you send a print job specifying POP Board from a computer beforehand, the type and size of
paper are shown on the Display Screen. Press the Load/Eject button.
Note
• If you will load heavyweight paper before sending a print job, press the Load/Eject button. After a
menu for selection of the type of paper is shown on the Display Screen, press ▲ or ▼ to select POP
Board, and then press the OK button. Next, a menu for selection of the paper size is shown on the
Display Screen. Press ▲ or ▼ to select the size of paper, and then press the OK button.
2. If Leave 70cm (28") space behind printer. is displayed, check the space behind the printer, lift
the four Front Tray Guides on the Ejection Guide, and then press the OK button.
Note
• Sufcient space behind the printer is required when loading paper in the Front Paper Feed Slot. For
details on the space required for installation, see “Specications”. (→P.76)
146 Handling Paper