Canon imageCLASS MF5950dw - Manual (Page 10)

1-8
Setting the wireless LAN
12.
Press [ ] to select, and press [OK].
13.
Wait until the machine retrieves the IP address
automatically (approx. 2 minutes).
14.
Check the network connections
Check the operation using a computer which is
connected to a network.
If you want to set the IP address manually, see the
following.
The Wi-Fi indicator blinks.
The next screen is displayed for approximately 2
seconds, and the Wi-Fi indicator will start blinking.
If an Error Message Appears
Press [OK] to close the screen, check if the network
key is correct, and follow the procedure from Step
7
again.
If the access point cannot be connected even after
retrying, see the following.
Proceed to “When an Error Message Appears,” on
p.2-2.
e-Manual “Network Settings” - “Basic Network
Settings” - “Setting the IP Address”
Proceed to “Checking the Wireless LAN Setting is
Completed,” on p.Appendix-1.
Do you want to
connect with new
settings?
No Yes
Connecting...
Cancel: Press Stop
Connected.
Next, install the software.
For details, please refer the “Starter Guide.”
The wireless LAN setting is completed.