Canon imageCLASS MF5950dw - Manual (Page 7)

1-5
Setting the wireless LAN
The next screen is displayed for approximately 2 seconds,
and the Wi-Fi indicator will start blinking.
10.
Wait until the machine retrieves the IP
address automatically (approx. 2 minutes).
11.
Check the network connections
If you want to set the IP address manually, see
the following.
e-Manual “Network Settings” - “Basic Network
Settings” - “Setting the IP Address”
Proceed to “Checking the Wireless LAN Setting
is Completed,” on p.Appendix-1.
Check the operation using a computer which is
connected to a network.
If an Error Message Appears
Press [OK] to close the screen, and repeat from
procedure
6
.
If the access point cannot be detected even after
retrying, see the following.
Proceed to “When an Error Message Appears,” on
p.2-2.
When the wireless LAN or access point is detected, the
WiFi indicator blinks.
Connected.
9.
Check that the Wi-Fi indicator is blinking.
Next, install the software.
For details, please refer the “Starter Guide.”
The wireless LAN setting is completed.