Canon imageCLASS MF5950dw - Manual (Page 9)

1-7
Setting the wireless LAN
9.
Press [ ] or [ ] to select the access point you
wrote down in step 2, and then press [OK].
Proceeding to
screen for entering
access point network
key.
Select Access Point
SampleABCD WEP 13
SampleEFGHIJ WPA-PS
SampleKL WPA2-PSK 9
SampleMNOP None 7
SSID is displayed in front of
"WEP" "WPA" "None."
10.
Press [ ] or [ ] to select the entry format that
matches the number of characters or digits that you
wrote down in step 2, and press [OK].
11.
Enter the network key that you wrote down in step 2.
 Hexadecimal
 ASCII text
WEP Key ( 5 Char.)
<Apply>
Entry Mode: aA
PSK ( 64 Digits)
<Apply>
1 2 3 4 5 6 7 8 9 0
A B C D E F
The following screen is displayed for approximately 5 seconds.
If multiple matched SSIDs are displayed, select the ID that
is listed first (the one with the strongest signal).
Either of the following screens is displayed.
Entry Format
8-63 Char. (ASCII)
64 Digits (Hex)
Entry Format
5 Char. (40bit ASCII)
13 Char. (104bit ASC
...
10 Digits (40bit Hex)
26 Digits (104bit Hex)
characters (digits)
If you cannot find the SSID, refer to the section below:
Proceed to “Checking SSID or Network Key for a Wireless
LAN Router/Access Point,” on p.Appendix-2.
1) Press [ ] to select <Entry Mode>.
2) Enter the network key.
* You can use the numeric keys.
3) Select <Apply> with [p] and [q], and then press
[OK].
1) Enter the network key.
* You can enter the key by selecting the characters with [t]
and [u], and press [OK].
2) Select <Apply> with [p] and [q], and then press
[OK].
 SSID
 Network Key
Write down the name of the access point to be selected in step 9.
Write down the network key to be entered in step 11.
 Write down the number of
characters in the network key
(number of digits)
MEMO