Checking the wireless lan setting is completed, Appendix – Canon imageCLASS MF5950dw User Manual
Page 18
Appendix-1
Appendix
1.
Press [
] (Status Monitor/Cancel).
2.
Select with [
] and [
], and then press [OK].
Status Monitor/Cancel
TX Job
RX Job
Fax Forwarding Erro
...
Network Information
3.
Select with [
] and [
], and then press [OK].
Network Information
IPv4
IPv6
Wireless LAN Informa
...
IEEE802.1X Error Inf
...
4.
Select with [
] and [
], and then press [OK].
IPv4
IP Address
Subnet Mask
Gateway Address
Host Name
5.
Take note of the IP address.
IP Address
6.
Press [
] (Status Monitor/Cancel) to close the
screen.
7.
Start the web browser of a computer which is
connected to a network.
Checking the Wireless LAN Setting is Completed
8.
Enter http://<IP address of the machine>/ in the
address field, and then press the [ENTER] key on your
keyboard.
The <IP address of the machine> is the address
noted in step
5
above.
http://
9.
Check that the screen of the Remote UI is displayed.
When the Remote UI is not displayed
Perform steps 1 to 9 again.
IF the RUI is still not displayed, please refer to
the following;
Proceed to “The Remote UI is not displayed,” on p. 2-5.