Canon XEED WUX450 - Manual (Page 302)

Menu Configuration
302
Factory default settings are set according to the following conditions.
*1 • [On] by default when HDMI ([HDMI In]) is [Auto]. [Off] by default when [HDMI] ([HDMI In]) is
[Computer].
*2 • For HDMI (when [HDMI In] is [Auto]), the factory default is [Off].
• For Component, the factory default is [Weak].
*3 • For Analog PC-1/2, Digital PC or HDMI (when [HDMI In] is [Computer]), the factory default is
[Off].
• [Weak] by default for Component or HDMI (when [HDMI In] is [Auto]).
*4 • [Off] by default for HDMI (when [HDMI In] is [Computer]), or for Digital PC, Analog PC (1 or 2),
USB, or LAN.
• HDMI (when [HDMI In] is [Auto]) or COMPONENT: Weak
Advanced adjustment
Ambient light (when Photo/sRGB is
selected)
Off*
P100
Adjust
Type Tungsten
Fluorescent
Level L
H
Noise reduction*2 Off P101
Weak
Middle
Strong
Dynamic gamma*3 Off P101
Weak
Middle
Strong
Mem. color correct*4 Flesh Off* P102
Sky Weak
Green Middle
Strong
6-axis color adjust Off* P102
Adjust
Hue / Saturation /
Brightness
Reset
Fine-Tune Gamma P103
Iris Off* P104
On
Lamp mode Full power* P105
Power saver
Reset OK / Cancel P105
*: Factory defaults (setting after reset)