Preparing the remote control, Installing remote control batteries – Canon XEED WUX450 User Manual

Page 33

Advertising
background image

33

Be
fo

re

Us
e

Preparing the Remote Control

Installing Remote Control Batteries

• If buttons on the remote control are inoperative when you attempt to operate the

projector, replace the batteries with new ones.

• Do not drop the remote control or subject it to impact.
• Do not spill any liquids on the remote control. Doing so could damage it.

Pay attention to the following points when handling the batteries.
Failing to do so could result in a fire or personal injury.
• Do not heat, short circuit or disassemble the batteries, or place

them in a fire.

• Do not attempt to recharge the batteries that are included with the

remote control.

• Remove the batteries when they are flat or when the remote control

will not be used for a long period of time.

• When replacing the batteries, replace both at the same time. Also,

do not use two batteries of a different type at the same time.

• Insert the batteries with the + and - terminals in the correct

directions.

• If any liquid from inside the batteries leaks out and contacts your

skin, be sure to wash the liquid off thoroughly.

3

Close the
compartment lid.
Slide the lid until you
hear a click to
securely close it.

2

Insert batteries.
Insert 2 new AAA
batteries in the
compartment with the
+ and – poles
positioned correctly.

1

Open the battery
compartment lid.
Slide the lid while
pressing it down.

Advertising