Electrolux EP19WI30LS - Manual (Page 5)

3
G
Quick Connect
Cord
Remote Controller Cord
Gas Supply Piping
Cold Water Supply
Hot Water
Remote Controller
Terminal Block
Cord
Connector Cord
Connector
3.
Quick Connect Multi System Installation
r
5IF
2VJDL
$POOFDU
.VMUJ
4ZTUFN
BMMPXT
UIF
JOTUBMMBUJPO
PG
UXP
VOJUT
UPHFUIFS
VUJMJ[JOH
POMZ
UIF
2VJDL

Connect Cord.
Typical Plumbing
* When connecting two units, use only a
single remote controller.
Note: Connect the remote
controller to only one
of the units.
System Diagram
r
*OTVMBUF
UIF
IPU
XBUFS
QJQJOH
UP
QSFWFOU
IFBU
MPTT
*OTVMBUF
BOE
BQQMZ
IFBUJOH
NBUFSJBMT
UP

the cold water supply piping to prevent heat loss and freezing of pipes when exposed to
excessively cold temperatures.
Union
Make this distance as short
as possible.
* The hot water temperature
will become unstable as the
pipe length increases.
Distance at center: 20.3 - 36.3 in. (515 - 922mm)
Quick Connect Cord Union
Gas Valve
Union
Shutoff Valve
Shutoff Valve
Hot Water
Shutoff Valve
Cold Water
Distance on sides
2 - 18 in. (50 - 457mm)
Leave enough clearance around the plumbing to
apply insulation. It will be necessary to add
bends to the piping to ensure that this clearance
is available.
Size the piping to allow for the
maximum flow rates of the units.
The backflow preventer is
put up before it diverges.
Pressure
Relief Valve
5IF
2VJDL
$POOFDU
$PSE
JT

GU N

MPOH
*OTUBMM
UIF
VOJUT



NN

BQBSU
GSPN
FBDI

other to ensure the cord will be able to reach between the units. (See Typical Plumbing diagram).
(If the distance between the two units is too great, not only will the cord not be able to reach,
but the water temperature may also become unstable because of the difference in pipe length
between the two units).