Electrolux EXH09HL1WI - Manual (Page 9)

ENGLISH 9
8 °C heating function
In HEAT mode, simultaneously press
the ION-FILTER button and the CLOCK
button to enable or disable the 8 °C
heating function. The display shows
”8 °C” (”46 °F”). The unit starts to heat
when the temperature drops below
8 °C. Fan Speed will be AUTO and
cannot be changed.
Replacng the batteries
The remote control operates with two
1.5V AAA batteries.
1. Open the battery compartment.
2. Remove the old batteries.
3. Insert the new batteries. Make sure
that the positive (+) and negative (-)
markings on the batteries match the
positive (+) and negative (-) markings
on the battery compartment.
4. Close the battery compartment.
CAUTION
r© !LWAYS©USE©NEW©BATTERIES©OF©THE©SAME©
type. Do not use old batteries or
different batteries types.
r© 2EMOVE©THE©BATTERIES©WHEN©THE©
remote control will not be used for a
long time.
NOTE
r© /PERATE©THE©REMOTE©CONTROL©WITHIN©ITS©
transmitting and receiving range.
r© /PERATE©THE©REMOTE©CONTROL©AT©LEAST©
1 m away from your TV set or stereo
sound set.
r© !IM©THE©REMOTE©CONTROL©AT©THE©RECEIVER©
of the main unit to improve the
receiving sensitivity of the main unit.
r© )F©THE©REMOTE©CONTROL©TRANSMITS©A©
signal, the transmitting symbol will
blink for 1 second. The bell will ring if
the main unit receives the signal.
r© )F©THE©REMOTE©CONTROL©DOES©NOT©OPERATE©
normally, remove the batteries
and insert them again 30 seconds
later. If the remote control still does
not operate normally, replace the
batteries.
Emergency operation
If the remote control cannot be used,
use the AUTO/STOP button on the
main unit. The unit will operate in AUTO
mode. The temperature or fan speed
cannot be changed.
1. Press the AUTO/STOP button
to switch on the unit. The unit
automatically sets the operation
mode.
2. Press the AUTO/STOP button again
to switch off the unit.
Mode Model Temperature setting Fan speed
AUTO Cooling only 25 °C (COOL, FAN) AUTO
AUTO Heat pump 25 °C (COOL, FAN) AUTO
AUTO Heat pump 20 °C (HEAT) AUTO