Electrolux EXH12HL1WE - Manual (Page 15)

ENGLISH 15
refrigerant circuit because the circuit
operating temperature is high.
• The pipes connecting the indoor and
outdoor unit are not included in the
unit.
• The outdoor unit is powered by the
indoor unit.
Installation site
• Do not install the unit in areas with:
- strong heat sources;
- vapours or flammable gasses;
- contamination with oil particles;
- high frequency electromagnetic
equipment (e.g. welding equipment or
medical devices);
- high salinity (e.g. close to coastal
areas);
- sulphuric gas (e.g hot water springs);
- poor air quality.
Indoor unit
• Maintain the minimum installation
distances specified in this document.
Do not block the air inlet or the air
outlet.
• Do not use the unit in places with
extremely high humidity.
• Install the indoor unit out of reach of
children.
• The wall must be strong enough to
support the weight and vibration of
the unit.
• Install the indoor unit at least 50 cm
above the floor surface.
• Leave sufficient space for cleaning
and maintenance.
• The air filter should remain accessible.
• Leave at least 1 m distance
between the unit and other electrical
appliances.
• Install the indoor unit in a place where
the condensate water can be easily
drained.
• Install at a location protected from
direct sunlight.
Outdoor unit
• Maintain the minimum installation
distances specified in this document.
• Do not block the air inlet or the air
outlet.
• Install the outdoor unit out of reach of
children.
• Install the outdoor unit where there is
sufficient ventilation.
• Install the outdoor unit where
produced noise and airflow will not
disturb neighbors or animals.
• Install the outdoor unit in a dry place.
• Install the outdoor unit in a place not
exposed to direct sunlight or strong
wind.
• Install the unit in a place that supports
the weight and vibration of the unit.
• The height difference between the
indoor unit and the outdoor unit must
be less than 5 m.
• The length of the connecting pipes
must be less than 10 m.
• Leave sufficient space for cleaning
and maintenance.
• The outdoor unit is powered by the
indoor unit.
Safety precautions for electrical
appliances
• Use a dedicated mains circuit.
• The unit must be properly grounded.
• Install a Residual-current device
(RCD) to protect against personal
injury in case of leakage currents.
• Use an all pole disconnection switch
with a contact separation of at least
3 mm in all poles in fixed wiring. For
models with a mains plug, make sure
that the mains plug is within reach
after installation.
• The installation must comply with
local electrical safety regulations and
with other relevant local regulations
• The unit must be installed in
accordance with national wiring
regulations.