Electrolux EQW4111BOG - Manual (Page 52)

• Make sure that the appliance is not dam-
aged because of transport. Do not con-
nect a damaged appliance. If it is neces-
sary, speak to the supplier.
• Only use built-in appliances after you as-
semble the appliance into correct built-in
units and work surfaces that obey the
standards.
• Do not install the hob over a domestic
appliances if these do not allow it.
• Install the appliance only on worktop
with flat surface.
• Do not change the specifications or
modify this product. There is the risk of
injury and damage to the appliance.
• Fully obey the laws, ordinances, direc-
tives and standards in force in the coun-
try where you use the appliance (safety
regulations, recycling regulations, electri-
cal safety rules etc.)
• The adjustment conditions for this appli-
ance are stated on the label (or data
plate).
• This appliance is not connected to a
combustion products evacuation device.
It shall be installed and connected in ac-
cordance with current installation regula-
tions. Particular attention shall be given
to the relevant requirements regarding
ventilation
• Keep the minimum distances to other
appliances and units.
• Install anti-shock protection, for example
install the drawers only with a protective
panel directly below the appliance.
• Prevent damage of the cut surfaces of
the worktop against moisture with a cor-
rect sealant.
• Seal the appliance to the worktop with
no space left with a correct sealant.
• Prevent damage of the bottom of the ap-
pliance from steam and moisture, e.g.
from a dishwasher or oven.
• Do not install the appliance adjacent to
doors and below windows. If not, hot
cookware can be hit off the hob when
you open the doors or windows.
• Prior to installation, ensure that the local
distribution conditions (nature of the gas
and gas pressure) and the adjustment of
the appliance are compatible.
• This appliance is not connected to a
combustion products evacuation device.
It must be installed and connected in ac-
cordance with current installation regula-
tions. Particular attention must be given
to the relevant requirements regarding
ventilation.
• The use of a gas cooking appliance
cause heat and moisture in the room
in which it is installed. Make sure
that the ventilation in kitchen is
good: keep natural ventilation holes
open or install a mechanical ventila-
tion device (mechanical extractor
hood).
• More ventilation (for example open-
ing of a window or increasing the
level of mechanical ventilation where
present) is necessary when you in-
tensive operate the appliance for a
long time.
If, you use the accessory frame C-FRAME,
first read the instruction supplied with the
frame before you install the appliance.
WARNING!
Risk of injury from electrical cur-
rent. Carefully obey the instructions
for electrical connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Install correctly to give anti-shock pro-
tection.
• Loose and incorrect mains plug and
socket connections can make the termi-
nal become too hot.
• A qualified electrician must install the
clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable
and replace the damaged mains cable
with proper special cable. Speak your lo-
cal Service Force Centre.
The appliance must have the electrical in-
stallation which lets you disconnect the ap-
pliance from the mains at all poles with a
contact opening width of minimum 3 mm.
You must have correct isolation devices:
line protecting cut-outs, fuses (screw type
fuses removed from the holder), ground
leakage trips and contactors.
Manufacturer is not responsible for
any injury to persons and pets or dam-
age to property caused by failure to
obey these requirements.
52 www.electrolux.com