Electrolux EQW4111BOG - Manual (Page 62)

• Pull off the excess silicone with the scra-
per.
THE INSTALLATION OF MORE THAN ONE APPLIANCE
Added parts:connection bar(s), heat re-
sistant silicon, rubber shape, sealing strap. Only use special a heat - resistant
silicon.
580 mm
520 mm 490 mm
360 mm
+ - =
20 mm 920 mm
The worktop cut out
Distance from the wall : minimum 50 mm
Depth : 490 mm
Width : sum widths of all the appliances to
be built-in and subtract 20 mm (see also
"Overview of all appliance widths" )
The installation of more than one appliance
1. Put down the dimension of the work-
top cut out and saw it out.
2. Put the appliances one at time on
some soft surface, a blanket for exam-
ple, with the bottom side up.
3. Put the seal stripe around the lower
edge of the appliance along the outer
edge of the glass ceramic.
4. Loosely screw the fixing plates into the
appropriate holes in the protective
casing.
5. Put the first appliance in the worktop
cut out. Put the connection bar in the
worktop cut out and push up half of
the width against the appliance.
6. Loosely turn in fixing plates from be-
low on the worktop and on the con-
nection bar.
7. Put the subsequent appliance in the
worktop cut out . Make sure that the
front ends of the appliances are on the
same level.
8. Tighten the fixing plate / retaining grip
screws.
62 www.electrolux.com