Electrolux EQW4111BOG - Manual (Page 59)

INSTALLATION
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
WARNING!
The following instructions about in-
stallation, connection and mainte-
nance must be carried out by quali-
fied personnel in compliance with
standards and local regulations in
force.
GAS CONNECTION
Make sure that during the installation the
appliance is not connected to electrical
supply. Disconnect the mains plug or deac-
tivate the fuses. Disconnect the mains gas
supply.
Make sure that there is a stop tap assem-
bled between the gas supply of house and
the appliance.
The settings for this appliance are located
on the rating plate. The present settings for
the type of gas and gas pressure are on a
sticker
Choose fixed connections or use a flexible
pipe in stainless steel in compliance with
the regulation in force. If you use flexible
metallic pipes, be careful they do not come
in touch with mobile parts or they are not
squeezed. Also be careful when the hob is
put together with an oven.
This appliance is not connected to an ex-
haust gas outlet. It must be connected in
accordance with the installation conditions
that apply. Pay special attention to correct
airflow.
Make sure that the gas supply pressure of
the appliance obeys the recommended val-
ues. The adjustable connection is fixed to
the comprehensive ramp by means of a
threaded nut G 1/2". Screw the parts with-
out force, adjust the connection in the nec-
essary direction and tighten everything.
A B C
A) End of shaft with nut
B) Gasket
C) Elbow
WARNING!
After installation always check the
tightness of the connections using
a soap solution. Never use a
flame to check the tightness.
Flexible nonmetal pipes
connection:
If it is possible to easily control the connec-
tion in its full area, you can use a flexible
pipe. Tightly attach the flexible pipe by
clamps.
Liquid gas: use the rubber pipe holder. Al-
ways engage the gasket. Then continue
with the gas connection. The flexible pipe is
prepared for apply when:
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting
edges or corners;
– it can be easily examined in order to
check its condition.
The control of preservation of the flexible
pipe consists in checking that:
– it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
– the material is not hardened, but shows
its correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
ENGLISH 59