Electrolux EQW4111BOG - Manual (Page 58)

TROUBLESHOOTING
Problem Possible cause Remedy
There is no spark when
lighting the gas • There is no electrical
supply
• Make sure that the unit
is connected and the
electrical supply is
switched on.
• Control the fuse. If the
fuse is released more
than one time, refer to a
qualified electrician.
• Burner cap and crown
are placed uneven
• Make sure that the
burner cap and crown
are in correct positions.
The flame is blow out im-
mediately after ignition • Thermocouple is not
heated sufficient
• After lightning the flame,
keep the knob pushed
for approximately 5 sec-
onds.
The gas ring burns un-
evenly • Burner crown is blocked
with food residues
• Make sure that the in-
jector is not blocked
and the burner crown is
clear of food particles.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, speak
your dealer or the local Service Force Cen-
tre.
If you operated the appliance incor-
rectly, or the installation was not
carried out by a registered engi-
neer, the visit from the customer
service technician or dealer may
not take place free of charge, even
during the warranty period.
58 www.electrolux.com