6 error messages – AKG Acoustics PT 4500 User Manual

Page 35

Advertising
background image

6 Error Messages

35

PT 4500

Error Messages

Problem

Remedy

Err.>rF<

PLL error. (Receiver unable to lock on
to selected frequency.)

1. Press setup switch briefly and set

different frequency.

2. If problem persists, contact your

nearest AKG Service Center.

Err.>SYS<

Frequency settings cannot be changed. 1. Switch power to transmitter OFF and

back ON after about 10 seconds.

2. If problem persists, contact your

nearest AKG Service Center.

Err.>USr<

Last setting cannot be loaded.

1. Set frequency again.
2. If problem occurs frequently, contact

your nearest AKG Service Center.

Err.>FrE<

Frequencies cannot be selected from
Frequency screen.

1. Continue with previous setting.
2. Press setup switch briefly and set

frequency from Preset screen.

3. If problem occurs frequently, con-

tact your nearest AKG Service Cen-
ter.

Err.>PrE<
(comes up on powering up or when try-
ing to select a Preset and appears on
receiver, too.)

All Presets defective; no Preset selec-
table.

1. Use frequency screen to set fre-

quency
(section 3.6.2).

2. Contact your nearest AKG Service

Center.

Err.>PrE<
(comes up on powering up only and
does not appear on receiver.)

One or more Presets defective.

1. You can select Presets, but note

that defective Presets will not be
available.

2. Contact your nearest AKG Service

Center.

Err.>rPt<

No remaining battery life data available. 1. Check batteries: replace standard

rechargeable batteries immediately
with dry batteries or AKG BP 4000
battery pack.

2. Remove and reinsert BP 4000 bat-

tery pack.

3. If error persists, charge battery

pack.

4. If error occurs with several different

battery packs or types of dry bat-
teries, contact your nearest AKG
Service Center.

Err.>AF<

No signal at audio input.

1. Check microphone element.
2. Mount microphone element.
3. Briefly push setup switch.
4. If error occurs frequently, contact

your nearest AKG Service Center.

Rec.>Acc<

BP 4000 battery pack needs recovery.

• Run recovery cycle. Refer to User

Manual of optional CU 4000
charger.

Advertising