Aiwa XH-A1000 - Manual (Page 23)

22
ENGLISH
5 Press DISC DIRECT PLAY, then press one of the
numbered buttons 1-3 within 3 seconds to select
a disc. Then, press the numbered buttons 0-9 and
+10 to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY and 2, then +10 and 0.
6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK to select side B and
program the tracks for side B.
After confirming B on the display, repeat step 5.
8 Press q REC/REC MUTE, and then press
c / d within 2 seconds to start recording.
The tape is rewound to the beginning of the side facing
upward, the lead segment is played through for 10 seconds,
and recording starts. When recording on the side A facing
upward ends, recording on the other side B starts.
To stop recording
Press s . Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press
f or g repeatedly.
To change the program of each side
Press CD EDIT/CHECK to select side A or B, and press
s CLEAR to clear the program on the selected side. Then
program tracks again.
To clear the edit program
Press s CLEAR twice so that the line of EDIT disappears from
the display.
PROGRAMMED EDIT RECORDING
In the programmed edit recording function, the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
NOTE
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from steps 3 to 8.
1 Load the tape into the cassette tray, and press
DOLBY NR to turn Dolby NR on or off.
Load the tape with the side to be recorded on first facing
upward.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice.
The lines of PRGM EDIT and “PRGM” light up on the display.
When “AI” is selected, press CD EDIT/CHECK again.
4 Press the numbered buttons 0-9 to designate the
tape length.
10 to 99 minutes can be specified.
• f , g and MULTI JOG are also available to designate
the tape length.
PRGM
Tape length Tape side A
Maximum recording
time for side A
Tape side B(reverse side)
Track number
Program number
Disc number
Programmed track numbers
PRGM EDIT
CD
s
q
c / d
CD EDIT/
CHECK
0-9,+10
f , g
DISC
DIRECT
PLAY
Programmed track numbers Selected disc
number Program number
Remaining time on side A Selected track number