AT&T E5655 - Manual (Page 23)

21
Telephone Operation
Base settings
Handset Locator
This feature is used as an aid to locate the handset(s). It
can only be activated from the base. Press
SELECT/MENU
and then press the ^ or V key until
the HANDSET LOCATOR option is shown. Press
SELECT/MENU
. The screen on the base will show
"PAGING ALL HANDSETS" and start the paging
tone at the handset(s) for 60 seconds.
To stop the paging tone, press
PHONE
,
SPEAKER
or
press any dial pad key on the handset or press
CLEAR
on the base.
NOTE: The handset ringer volume also determines the level of the pag-
ing tone. If the handset ringer volume level is set to off (0), that handset will
be silenced for all calls and paging (see page 17).
Display Base ID
Press
SELECT/MENU
and then press the ^ or V key
until the DISPLAY BASE ID option is shown. Press
SELECT/MENU
to show the base ID number. This num-
ber can be used when adding, replacing, or re-register-
ing handsets (see page 46-48).
Dial Type
At this menu you can choose Tone or Pulse dialing. The
factory default setting is
TONE
. Change this to
PULSE
only if you do not have touch-tone dialing service.
Use the
^V buttons to select
TONE
or
PULSE
, then
press
SELECT/MENU
to save your preference.
NOTE: This sets the dial type for both the handset(s) and the base.
DIAL TYPE
TONE
>HANDSET LOCATOR
DISPLAY BASE ID
>DISPLAY BASE ID
DIAL TYPE
91-000373-030-000_E5655_R4.qxd 11/1/2005 10:04 AM Page 21