AT&T E5655 - Manual (Page 34)

32
Answering System Operation
Day and time announcements
To set day and time
Before playing each message, the answering system
announces the day and time the message was received.
Before using the answering system, you should follow
the steps at left to set the day and time, so messages
are dated correctly.
The system uses voice prompts to guide you. Each time
you press
CHANGE
, the day, hour, minute or year
advances by one. When you hear the correct setting,
press
TIME/SET
to move to the next setting.
To check day and time
You can press
TIME/SET
at any time to hear the
current day and time without changing it.
NOTE: Press and hold CHANGE to advance the minute or year by
increments of 10 (the year can be set from 2000 to 2039).
NOTE: Caller ID provides the time and date. Set the year so that the
day of the week can be calculated from the Caller ID information. After you
set the time once, it will thereafter be set automatically with incoming Caller
ID information. The time will be set automatically only if you subscribe to
Caller ID service provided by your local telephone company (see page 5).
1. Press TIME/SET
The system will announce the cur-
rent clock setting, then announces
“To change clock, Press TIME
SET!¨
2. Press TIME/SET
3. Press CHANGE
4. Press CHANGE
Press CHANGE
until the system announces the cor-
rect hour, then press TIME/SET.
until the system announces the cor-
rect minutes, then press
TIME/SET
.
NOTE: You can press and
hold CHANGE to advance
the minutes in increments of ten.
until the system announces the cor-
rect day, then press TIME/SET.
5.
6. Press CHANGE
until the system announces the correct
year, then press TIME/SET. The
system announces the current
clock setting.
91-000373-030-000_E5655_R4.qxd 11/1/2005 10:05 AM Page 32