AT&T Telephone Adapter - Manual (Page 18)

16
6
ACTIVATE
YOUR TELEPHONE ADAPTER
B
!
IMPORTANT! If you are
using a VPN service/client,
disable it while you follow
these steps.
C
A Go to your Personal Call
Manager Web site at
www.callvantage.att.com .
B Login using your User ID
(your 10-digit AT&T
CallVantage SM Service
number) and password.
This was part of the informa-
tion to gather in Step 1.
C You should see the screen
at left. Click “Activate TA”
and follow the instructions
on the screen.
This process may take
5-30 minutes and you may
hear some clicking sounds
on your TA. DO NOT turn the
TA off while this sequence
is underway.
D When the online sequence
is complete you should
hear a single short ring on
the phone connected to
your TA.
E Pick up your telephone
handset and listen for a
dial tone. If you don’t hear
a dial tone, hang up, wait a
few seconds, and try again.
If you don’t get a dial tone
on your phone, see “I just
finished installation and
cannot get a dialtone” in
Troubleshooting, page 21.
NOTE
If you are using a VPN, you can
re-enable it now.