AT&T Telephone Adapter - Manual (Page 5)

33
TELEPHONE ADAPTER FRONT AND BACK ILLUSTRATION
1 2 3 4 5 9 8 7 6 11 10
1 Power LED
A solid green light indi-
cates that the unit
is powered correctly.
2 Status LED
The red status light will
blink until the TA has
been activated.
Once the
TA has been successfully
connected with the AT&T
CallVantage
SM Service,
it will light solid green.
The Status light will also
turn a blinking amber
color while downloading
the TA configuration
file or firmware updates.
IMPORTANT: DO NOT
power off your TA if the
Status LED light is amber.
3 WAN LED
A solid green light indi-
cates connection on the
WAN port. This LED blinks
during data transmission.
This light will blink while
downloading a configura-
tion file.
4 Ethernet LEDs
10M / 100M
A solid green indicates
a 100 Mb connection.
When this light is
off but the Link/Activity
light is green you have
a 10 Mb connection.
Link / Activity
Blinks during data trans-
mission. Off indicates no
connection.
5 Phone LED
PSTN/VoIP
This light is inactive
with the PSTN/VoIP
switch in the default
“VoIP” setting.
Hook / Ring
A solid green light indi-
cates that the phone is off
hook. When the light is
off this indicates that your
phone is on hook.
6 Receptor for Power
Adapter.
7 PSTN/VoIP Switch
By default, the switch
is set to VoIP.
8 Reset Button
Pressing this button re-
stores the TA to its original
factory default settings.
Note: To reset the TA, hold
the reset button down
WHILE you power up the
box, then continue to
HOLD the reset button.
9 WAN Port
This port is for the con-
nection of an Ethernet
cable to the cable or DSL
modem.
10 Ethernet Port
This port is for the con-
nection of an Ethernet
cable to your computer.
11 Phone Port
This port is for the
connection for an
RJ-11 telephone cord
to a phone.