ADTRAN 1200214L1 - Manual (Page 89)

61200214L1-1 IQ Probe User Manual 65
Chapter 9. System Configuration
Changing this option causes a complete system configuration and unit
reset.
Read Community (RD COMMUNITY)
Enter the authentication strings used for SNMP management.
Match the IQ Probe to the SNMP manager for read privileges. If
using front panel entry, see the section Entering Letters Using the
Front Panel in this chapter for more information.
Write Community (WR COMMUNITY)
Enter the authentication strings used for SNMP management.
Match the IQ Probe to the SNMP manager for write privileges.
If using front panel entry, see the section Entering Letters Using
the Front Panel in this chapter for more information.
Trap Mgr Options
The Trap Manager Options table defines routes for up to five
SNMP managers.
Trap Manager DLCI (TRAP DLCI)
If the trap manager port is set for DCE or DTE, this parameter
identifies the virtual circuit used for all traps generated by the IQ
Probe.
Trap Manager IP Address (TRAP IP)
Enter the IP address of the SNMP manager to which the IQ
Probe sends traps.
Trap Manager Port (TRAP PORT)
Enter the IQ Probe port used to transmit traps to the SNMP
manager. Choices are none, DTE port, DCE port, control port,
and ethernet port.