HP StoreEver Ultrium Tape Drives - Manual (Page 35)

6. If you have lost the use of a disk bay, we strongly recommend that you attach the supplied sticker
to the blanking plate of the disk bay to show that it is disconnected.
NOTE:
If you subsequently install a hard disk in this bay, it will not work. This does not mean there
is a fault with either the disk or the server.
7. Now go to “ Secure the drive - all servers ” on page 35.
Secure the drive - all servers
NOTE:
The server latches and side views of your server model may not be exactly the same as shown in the
illustrations. Please also refer to your server documentation.
Mounting hardware used
Ensure that you use the correct mounting rails or locating screws, as described in
“
Attach mounting hardware - some servers ” on page 21. The server also has a locking mechanism
to hold the tape drive in place.
1. Push the server latch down to lock the tape drive into position, as shown in Figure 21 on page 35.
1. Plastic rail
2. Server latch
Figure 21 Securing drive, mounting hardware used
. 2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
Ultrium Half-Height SAS Tape Drives 35