HP StoreEver Ultrium Tape Drives - Manual (Page 39)

3. Connect the SAS and power cords to the tape drive and plug the other end of the power cord
into the power outlet.
3. Power on/off switch 1. SAS connector
2. Power connector
Figure 25 Connecting the cables to the tape drive
.
Reboot the server
Switch on the tape drive and power up the server. The power on/off switch is on the front panel.
Watch the boot screen carefully after installation. If there are any error or unexpected messages go
back and check the SAS cabling carefully.
If this does not resolve the problem, refer to “ Troubleshooting ” on page 61 for further guidelines.
Ultrium Half-Height SAS Tape Drives 39