HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 181)

Virtual Connect modules 181
Row Description
Enclosure Name
Name of the enclosure (assigned through the Onboard Administrator)
Bay Number of the bay being summarized on this screen
Module Host Name Includes controls that enable you to set a custom host name for the module and
reset the module
Power Status/Control Power state of the device
The following table describes the rows within the Interconnect Bay Information table in the Bay Summary
screen.
Row Description
Part Number
The part number to be used when ordering an additional module of this type
Product Name
The common descriptive name of the module
Serial Number The unique serial number of the module
Dip Switch Setting The current physical setting of the system maintenance switches in a
hexadecimal format, where the least significant four bits of the value
correspond to the four switches and a bit value of 1 indicates the switch is in
the "on" position.
Spare Part Number The part number to be used when ordering a replacement module of this type
Manufacturer The manufacturer of the module
Firmware Rev The current firmware revision of the module
The following table describes the columns within the Uplink Port Information table in the Bay Summary
screen.
Column Description
Label Uplink port number
Network(s) Network name or the name of the shared uplink associated with this port
Status Shows the link status, link speed, and connectivity of the port. If the port is
unlinked and no connectivity exists, the cause is displayed. For more
information about possible causes, see "Port status conditions (on page
203 )."
Connector Type Displays the physical type of the faceplate connector, type of pluggable
module if one is present, or "Internal" to indicate the inter-switch link is active
on the VC-Enet module.
LAG ID Identifies the group of ports that have been aggregated together to form an
802.3ad Link Aggregation Group. This ID is unique only within a single
VC-Enet module, meaning the same LAG ID can be used on different VC-Enet
modules, but it is only meaningful for ports within the same VC-Enet module.
Connected to Displays the MAC address of the device that this port is connected to on the
other end. The remote device must support LLDP to display this information.
Detailed Statistics Click to display detailed statistics about this port.
The following table describes the columns within the Server Port Information table in the Bay Summary
screen.
Column Description
Label
Server side port number (determined by the device bay and NIC)
Flex NIC Flexible network interface card port
Physical server Number of the device bay and a description of the installed server blade